Using the arrow keys and the enter key to confirm your selections select Serial port setup. How can I find the serial port, so I can interface my old Terminal Node Controller with minicom? I remember the serial port working just fine on CentOS with the same system. The same port used to flash the board will be used for the monitor. To do this, under the Modem and Dialing menu, delete the Init and Reset strings. 0000:04:01.0: ttyS8 at I/O 0xcc20 (irq = 17, base_baud = 115200) is a 8250 Start Minicom in setup mode: Using the textual navigation menu, change the serial port settings to the following: Press Enter to exit the menus (pressing Esc will not save changes).Remove the modem Init and Reset strings, as we are not connecting to a modem. Use the built-in logs to identify the different serial ports on your system.
MINICOM SERIAL PORT INSTALL
sudo apt install minicom Using the minicom. Using minicom, AT commands can be sent to Shield/HATs available on Sixfab. 0000:04:01.0: ttyS6 at I/O 0xcc10 (irq = 17, base_baud = 115200) is a 8250 Minicom is a text-based serial port communications program. Optionally, you can communicate serial data through the Everyware Cloud. use minicom it is just a program which does everything Ive mentioned so far. Ensure that minicom is installed on the embedded device. 00:05: ttyS0 at I/O 0x3f8 (irq = 4, base_baud = 115200) is a 16550A All devices on Unix are mapped to a device file, the serial ports would be. I could not find anything with the key word "Serial": console enabled The output of dmesg | grep tty did not give me much useful information however. I want to use minicom to interface the serial port on this computer with Ubuntu installed. My dell dimension 8400 has a serial port on the back.